Fastvice: Endpost Anchor

Description

The FASTVICE and FASTSPLICE can fasten H-T wires without a tool. Merely insert the wires into the holes. The wires are gripped by spring-loaded clamps which tighten more securely as the wires are pulled harder, holding the wires at over 80% of the breaking strength of the wire itself. The FASTSPLICE is double sided for joining two ends of wire on in-line splices whereas the FASTVICE is half of a FASTSPLICE and is used for terminations at an end post. Each wire on a fence requires only one FASTVICE. To use the FASTVICE, drill a 10mm hole through the end post and pull the wire through the hole. Then insert the wire into the FASTVICE and tap it lightly into the hole. If final tensioning is to be done with the FASTVICE, it is recommended to use the Fastlink Tensioning Tool. It grabs the wire which has been threaded into the FASTVICE and a simple prying action pulls the wire through the FASTVICE to the desired tension. Alternatively, pull the wire to the end post with a chain grab, then push the slack through the hole and FASTVICE.